Search results

well theres a problem with my car, sounds like a bearing has collapsed. it gets louder the more speed you do, it is constant too, even when dipping the clutch. it is not making noise on idle while parked. it also changes note while turning corners, it gets very grindy going right, and not...

after prolonged periods of running, the car makes a strange whistling noise on idle, (quite loud) it goes away when driving though. i currently have no pcv setup as im not reving the car very high (and cant afford one :D) so dunno if its a pressure build up. any opinions?

hi lads, im currently building my b20. ive taken delivery of my engine from my builder and i have a quick question about the timing marks. upon picking it up he said the block was at TDC and the valve clearances were set... today ive put the pumps on and was test fitting the belt when i...

hi lads can anyone clear this up for me.. one of my buddys picked me up an itr oil pump in the US for cheap. i think i read somewhere recently the mounting points on the timing belt cover are different and if im using a usdm pump if to get a tb cover to suit. anyone confirm this?

got a headset there and cant figure out what the bigger objects are and where they go anyone?

hi lads. im currently building up a b series b18cR head at the moment... i bought it second hand and have never seen it running. im at the stage now where ive cnc'd the head and am replacing valve stem seals, valves, valve springs, retainers, cams, etc etc... is it in my best interests to...

hi lads i was just wonderin if your replacing your master cylinder (non abs) cause its leaking, can you replace it with an abs one? i heard somewhere the lines need to be flared or there one too many holes as one goes to the abs unit? can anyone enlighten me please? thanks alan

hi lads, just looking for opinions on these? i have one at the moment and wondering would i be better off with getting a different manifold. i got it cheap new and heard they were a very good mani but cant find many reviews on them.. thanks

is it possible to use 5mm spacers on oem honda wheel studs(EK/EG) with rays wheel nuts?

hi lads i was just wonderin if your replacing your master cylinder (non abs) cause its leaking, can you replace it with an abs one? i heard somewhere the lines need to be flared or there one too many holes as one goes to the abs unit? can anyone enlighten me please? thanks alan

anyone know where i could find one? please n thanks its for dc2

i currently have a b16a head and b18c (itr) head both are fine, have skunk2 gear there, cams,gears,springs,retainers,valves.. will i essentially have the same head which ever one i use? as the itr head is worth more to sell then the b16a head, just lookin to save money thanks

i recently had my b20 block honed retaining standard bore 84mm. my engineer wanted the pistons(wiesco 84mm) i was using to do the job. now after being honed i am forced to change pistons and worried about cylinders. i am now using the rs machined 84mm rep ITR pistons in my build...

hey guys, i recently started buyin parts for my forged b20 vtec, i bought a set of weisco pistons, they are quite high comp 14:1 afaik. my intentions were to run the engine on bioethanol, but as of january the 11th the irish government are not supporting the production of this...

hello all, names al from dublin ireland. rocking a b20'd si Integra. engine is out being rebuilt at the moment. happy to have joined:thanks: