Al-himself
New Member
- Joined
- Dec 12, 2010
- Messages
- 101
i recently had my b20 block honed retaining standard bore 84mm.
my engineer wanted the pistons(wiesco 84mm) i was using to do the job.
now after being honed i am forced to change pistons and worried about
cylinders.
i am now using the rs machined 84mm rep ITR pistons in my build.
will swapping pistons after honing present problems?
my engineer wanted the pistons(wiesco 84mm) i was using to do the job.
now after being honed i am forced to change pistons and worried about
cylinders.
i am now using the rs machined 84mm rep ITR pistons in my build.
will swapping pistons after honing present problems?