My B20 EK9 NEW (250bhp 160+tq)


Status
Not open for further replies.
Should be interesting to see the figures on this! You still using B20 block?
 
Dyno Graph will be intresting try and get a print out to post up. To compare to B18 and B20. As this is essecialy a B19 lol :nice:
 
Looking forward to you're dyno results.
You've waited ages so lets hope it was all worth it :)

Had my Daz built B20 for 12 months now and its been solid.
 
I assume he's only just running it in.

Would end up putting to much heat into the rings and bores and theres a chance of glazing or not bedding in the rings properly.

Beding in is almost just as important as the building itself.
 
Last edited:
KieranEG6 said:
Dyno Graph will be intresting try and get a print out to post up. To compare to B18 and B20. As this is essecialy a B19 lol :nice:
Click to expand...
this is a b18 with bigger bore so unfortunately you lose the handicap from bigger stroke. Gain in HP, but Nm's stays more or less at the same level as in b18's 87mm. Personally I like more bigger Nm number and lower redline then 9k rpm with b18's torque. But definitely will be fast :)
 
Its b20.

Heres the old dyno printout with some restrictive parts.

556134_10152132784460046_992552480_n.jpg
 
Status
Not open for further replies.
Back
Top