K20/24 eg - project 300+


Got my Jdm bootlid :)

5212a389-b1cc-b2c0.jpg
 
Jack-Civic said:
That's prob the next step just to go SC. I'll embarrass a few boys N/A first though :p

Yours will be up and running soon I take it? I think I seen you where running an RRC? I'm going to get one of these, where did you get yours from?
Click to expand...

speak to andrew baird at automek, http://automek.org/ , he can supply one ported to 70mm with the necessary mods done to fit straight up to a k20a / a2

yeah should be up and running this week :)
 
Great build and you got a serious engine I've seen it move and it can really move!!! Really jealous of it

Colour you choose for the bay looks like the colour in my ek9

9fd87378.jpg


Hard to get a picture of it
 
Yea was over looking at your car down showerks. Engine bays a nice job. Yea I've had a run in it around Dublin before aonghus mapped it. Serious machine. I'll upgrade a few wer bits on it. Valves, injectors, fuel pump and inlet, try make it my own. 5.1 will shift it on a bit more too.
 
Ye should go well, want to build an engine for mine just not sure what route to go, k20 or turbo b18, I would just be afraid of the k20 sitting so low in the bay and close to the ground
 
Got few pressies today.

Dc5 box with 5.1 final drive

5212a389-1ec1-a4b1.jpg


Carbonetic twin plate clutch

5212a389-1ede-9912.jpg


Tanabe sustec brace

5212a389-1eee-cf03.jpg
 
You must log in or register to reply here.
Back
Top