Zen
Member
- Joined
- Jun 20, 2007
- Messages
- 410
Its a year 2000 RX model in excellent condition inside and out with 80,000miles.
I bought the car off a forum member JoSh in October last year.
He kept The car immaculate and most of the modifications were done by him.
The car was imported by FastJapCars on this forum and has been converted to miles and limiter removed.
Engine:
DnrTuned built and mapped B20
B20Z1 Bottom End
Oem Polished and Balanced crank
Acl bearings
Dnr vtec conversion parts
Arp head studs.
New Cam Belt,Oil pump, seals and Gaskets
New Engine Oil, gearbox oil and coolant
Standard B16B Head with new stem seals
RS Machine 84mm 11.7:1 High Compression Pistons
Competition Stage 2 Carbon Kevlar Clutch
Spoon 4-2-1 Manifold
Spoon B-pipe
Spoon N1 Replica Muffler (not as loud)
Hondata S300 Ecu
Skunk2 Pro Series intake manifold bored out to 70mm
Skunk2 68mm throttle body
Itg DC2 Carbon Fibre Airbox with Cold Air feed
Itg Foam Air Filter
Suspension / brakes / wheels:
Desmond Regamaster Evo Wheels 15x7"
Volk Rays black locking wheel nuts.
Brigestone Potenza RE02 Tyres all round
MeisterR fully adjustable coilovers
Hardrace front/rear camber adjusters.
Skunk2 limited edition rear lower arms
Carbing 3 point front upper strut brace (aluminium).
Carbing rear upper strut brace (aluminium).
Carbing front lower strut brace (steel)
Blue titanium nuts and washers for front upper struts
Innovative black billet engine mounts with 65A inserts
Front Dixcel slotted discs.
Rear EBC plain discs
EBC yellowstuff pads all round.
MFactory short shifter and bushing kit
HEL braided lines all round.
Motul RBF600 Brake fluid.
Exterior / interior:
Skunk2 black solonoid cap
MFactory engine/gearbox magnetic plugs
NGK Blue tension leads
Red Aluminium Air Intake Arm with Silicone sleeves
Aircon removed.
Team Heko Wind Deflectors
Black sunstrip professionally fitted.
Bosch flat wiper blades.
2 heavy duty engine earth leads.
Oakley resevoir socks.
Osram Nightbreaker Plus H4 Headlight Bulbs
Fog light integrated into rear light cluster.
Rear upper strut cut-outs fited with rubber trim.
Jdm C/W Mist Style Wiper Jets
NRG Short Hub
NRG Gen 2.5 Quick Release Kit
Nardi Deep Corn Wheel
OEM Parts Replaced:
Cambelt and Tensioner done @ 60k miles.
Thermostat.
Headlights.
Wiper arms.
Rear droplinks.
Rear brake nipples and bolts.
Roof strips.
Type R Decals
Inner door membranes.
Front and rear 'H' badges.
Fuel filter.
Bumper supports.
Rear light seals
Pollen filter
Aircon bulkhead rubber bung.
Aircon block off plate.
In the next few weeks I should have my B20 Vtec Engine Fitted.
Here's the pics, hope you like.
I bought the car off a forum member JoSh in October last year.
He kept The car immaculate and most of the modifications were done by him.
The car was imported by FastJapCars on this forum and has been converted to miles and limiter removed.
Engine:
DnrTuned built and mapped B20
B20Z1 Bottom End
Oem Polished and Balanced crank
Acl bearings
Dnr vtec conversion parts
Arp head studs.
New Cam Belt,Oil pump, seals and Gaskets
New Engine Oil, gearbox oil and coolant
Standard B16B Head with new stem seals
RS Machine 84mm 11.7:1 High Compression Pistons
Competition Stage 2 Carbon Kevlar Clutch
Spoon 4-2-1 Manifold
Spoon B-pipe
Spoon N1 Replica Muffler (not as loud)
Hondata S300 Ecu
Skunk2 Pro Series intake manifold bored out to 70mm
Skunk2 68mm throttle body
Itg DC2 Carbon Fibre Airbox with Cold Air feed
Itg Foam Air Filter
Suspension / brakes / wheels:
Desmond Regamaster Evo Wheels 15x7"
Volk Rays black locking wheel nuts.
Brigestone Potenza RE02 Tyres all round
MeisterR fully adjustable coilovers
Hardrace front/rear camber adjusters.
Skunk2 limited edition rear lower arms
Carbing 3 point front upper strut brace (aluminium).
Carbing rear upper strut brace (aluminium).
Carbing front lower strut brace (steel)
Blue titanium nuts and washers for front upper struts
Innovative black billet engine mounts with 65A inserts
Front Dixcel slotted discs.
Rear EBC plain discs
EBC yellowstuff pads all round.
MFactory short shifter and bushing kit
HEL braided lines all round.
Motul RBF600 Brake fluid.
Exterior / interior:
Skunk2 black solonoid cap
MFactory engine/gearbox magnetic plugs
NGK Blue tension leads
Red Aluminium Air Intake Arm with Silicone sleeves
Aircon removed.
Team Heko Wind Deflectors
Black sunstrip professionally fitted.
Bosch flat wiper blades.
2 heavy duty engine earth leads.
Oakley resevoir socks.
Osram Nightbreaker Plus H4 Headlight Bulbs
Fog light integrated into rear light cluster.
Rear upper strut cut-outs fited with rubber trim.
Jdm C/W Mist Style Wiper Jets
NRG Short Hub
NRG Gen 2.5 Quick Release Kit
Nardi Deep Corn Wheel
OEM Parts Replaced:
Cambelt and Tensioner done @ 60k miles.
Thermostat.
Headlights.
Wiper arms.
Rear droplinks.
Rear brake nipples and bolts.
Roof strips.
Type R Decals
Inner door membranes.
Front and rear 'H' badges.
Fuel filter.
Bumper supports.
Rear light seals
Pollen filter
Aircon bulkhead rubber bung.
Aircon block off plate.
In the next few weeks I should have my B20 Vtec Engine Fitted.
Here's the pics, hope you like.
Last edited: