i'm about to change, well put inserts in mine, on saturday.
I'm planning to take pics and make a guide. so if you can wait i'll see if i can give a step by step.
But from previous one i've done it wasn't too bad, forgot how i did it tho
Just FYI my innovative mounts are sagging. There is about a 1/8 - 1/4 inch gap where the urethane has been impressioned by the engine torque. It's been about 9 months. I'm picking up a set of hard rubber mounts to prevent this problem from happening again.Looking forward to a write up on this, have had a set of innovative mounts sitting in my shed for ages now, but not enough time to commit to the job!
Hopefully a write up will give me a better idea of how much time i'll need!
Did this mount today,Steven's method of removing the bolts leaving the L shaped bracket loose is what worked for me,didnt have to remove anything else other than the airbox pipe for access to the mount,was easier than i thought it would be.
also had a look at my torque mounts and they are knackered .
Just FYI my innovative mounts are sagging. There is about a 1/8 - 1/4 inch gap where the urethane has been impressioned by the engine torque. It's been about 9 months. I'm picking up a set of hard rubber mounts to prevent this problem from happening again.