Search results

Hi, the brake booster and master cylinder from CR-V 1998 fits on Ek4? Regards

Hi, I have a problem on my electrical system. I have Honda civic ek4 and I bought a new battery but I check after 6 months the battery pours acid. I have audio Capacitor with 5farads, can I use on my electrical system?

Hi, Theres any diference between EK4 ABS and EK9 ABS? EK4 ABS is too sensitive.

Hi, Where i buy in EU a rebulid ITR motor? I have stock B16A2 on my EK4 but I think is better to spend money on rebuild B18

Hi my B16A2 have 185.000km and i use Shell Helix H7 Oil 10W40. I can use Shell Helix Ultra Range? theres any advantages on this oil for B16A2? Regards

Hi, I have MG ZR calipers on my EK4, I want to know if i can install MG TF calipers on my car. MG TF have 2 cylinders per caliper. Regards

Hi, Where i can buy on Europe anti-roll bars for Honda Civic EK4? I have stock anti-roll bars, whats is the best i can install on EK4? I have Koni Sport suspension.

Hi, I try to create a project for my EK4 brakes. - ITR Brake booster with master cylinder - MG ZR Calipers - MG ZR front disk brakes 282mm - MG ZR back disk brakes 260mm - stopper brake booster - steel brake lines Theres any better modifications? Regards

Hi, I have the B16A2 EK4, i have this mods 1- cold Air intake 2- Exedy oem cluth with F1 racing flywheel 3- NGK Iridium Sparks 4- Final pipe exaust 5- EBC disk brakes 6-stell brake lines GOODRIDGE I have doubt what i need to buy for increase performance spend a little money. (Light...

Hi, I bought Exedy oem clutch and F1 racing flywhell. I installed everything right. When i release the cluth at 800rpm ~ 1500rpm the motor make a much vibration. I dont know what happen with my cluth kit.:(( I bought the kit on http://www.gripforce.com can someone help?

Hi, The rear motor mount is the same civic 6 gen and 1gen CRV? I need to buy a good rear mount for CRV. Where i can find a sheap mount? Best regards

Hi, Im searching for fog light oem harness, i only need switch harness and fog light harness. When i swap my engine to B16A2 i lost the original harness.

Hi, I live in Madeira Island and where we have a lot of roads with curves. I have OEM swaybar of EK4 and i want to now what is the best size for my car setup. Best regards

Whats diffrence EK3 brake booster and ITR brake booster?

Hi, My rear caliper are broke (handbrake pin doesnt work) i try to repair but it still no handbrake. I try to buy repair kit Honda genuine but it the same.. Where i can find rear calipers? Best regards

Hi, I have Europen Honda CRV 1998 Made in japan (left steering wheel), i need to buy a Timing belt KIT and upper arm on ebay USA but i dont know if fit on my engine. My engine is a B20B3. here is a Timing belt KIT EBay Timing belt kit

I notice that my engine consume some oil (165,000Km) What i need to do 1st with this problem? I realy change all gaskets (Vtec, valve cover,screws of valve cover, spark valve cover) I use Shell Helix HX7 10W40 here air temperature is 18cº~25cº with 80% humidity regards

Hi, Im trying to buy a upper arm for Honda CR-V 1998 but on ebay is expansive. The Civic 98 upper arm is the same for CR-V? Best regards

Hi, My car have 160,000km. I notice that the engine loss some oil. i changed the seals of the engine minus the crankcase, and i notice the oil drops some km. What i need to do? Regards

Hi, Anyone knows how to repair Honda CR-V Clock? Regards