Search results

hi I'm after a b18c/6 and s80 box . No smokers , knocking or crunchy gearboxes Can pickup depending on location Cash waiting Thanks

quick question , just found the bung for the exhaust and the outlet is around 22mm i mean its absolutely tiny , surely this has a performance restriction on the car ? The reason ive got the bung out is knockhill have a trackday on sunday and they require the vehicle to be under 110db ...

thinking about changing my injectors , the ones on my b16 are nearing 100k so instead of getting them asnu cleaned i was going to get new prelude injectors which if i recall works out cheaper and also would be a slight upgrade . am i right in doing this or wasting my time? truthful...

just as the title pleasee :)

basically im upgrading my inlet manifold soon , but im stuck between two ideas . im sticking to honda , dont know why just seems right haha my choices are 1. itr inet and itr tb 2. b16 inlet and itr tb BUT cut open and smoothed down bored out a bit . reason behind this is the itr looses...

just as the title , cash waiting

am i right in saying that the only difference in the two is the last gear i.e the 4.7 is shorter ?

basically im needing a new clutch , i previously had a f1 racing stage 2 fitted to my 195hp b16 but it disintegrated going down the 1/4 mile. the reslut in this was a hole in the housing of the gearbox . thankfully the block is fine but im needing a new gearbox . :nerv: for the clutch , ive...

i need help guys , just to get rid of the last two codes ( i had 4 lol) . Ive put an obd1 b16a2 into my 99 ej9 with the obd1 ecu for the engine ive used an ek9 engine loom ( i have cut and sorted the plugs for the conversion ) but this isnt to do with the codes its throwing . my ecu is...

here's the story, i went to plug my iat sensor in today, but the plug on my loom is round and has black and yellow + black and blue wires running from it , the IAT sensor that i have is rectangular type but the wires from that are green and black + red and yellow . im going to join the wires but...

Hi Guys , reason being is I've got a b16a2 obd1 engine going into an ek and I'm using an obd2 loom , the obd2 doesn't run the vtec oil preassure plug but I'm using a obd1 ecu (p30) . I know the ecu will thow up a code because its looking for the Vps , does this mean I have to run wires from it...

what do YOU think is the better filter for your honda ? :nice: Cheers :D

doe's anyone know how to use the ek9.org discount when purchasing oil off of opieoils ? Cheers

As title , cash waiting

Just as the title , pm me !:)

Right , I'm needing to order my bearings soon ,so I went to check the Rods , the rods from cylinders 1,2,4 are browny colour ? So I'm guessig they are or were pink? And rod from cyl 3 is green , what does this mean ? If they were all green I was going to just get acl's , but seeing there...

anyone know of a place to get any ? or is there traders on here that stock them ? Thankyou .

As the title guys

where is the best place to get these from ? ive seen them on ebay , funkypower etc but i was just curious to find out the cheapest place. Cheers

as the title .