Hi
I have and issue with my car where i experince bad vibration on acceleration with my car.
I have been told that it's the differential bearings. But i Am of teh opnion that it's the right hand side inner CV joint. My gearbox is quiet without any humming sounds or anything strange.
I...
A buddy of mine has a freshly built B18c.
Motor set-up is as follows
JDM B18c (GSR) block
.25 over bore with PR3 pistons
B16a head with Supertech valvetraim
OEM 3 layer HG
S2 Pro 1 cams, set to +3/+3 ( this is what the motor liked best, based on the dyno graph)
Skunk 2 Pro series...
The time has come for me to choose a set of cams for my B16a6. I want a drop in cam that does not need much tuning to get to their full potential. I would prefer a set of ITR / CTR cams, but these are proving very difficult to get hold of. I may be able to get my hands on a set of crower 401's...
Gents
What are the pros and cons of fitting a 62mm TB to a B16a6?
The current setup is as follows:
Internally stock engine
57mm freeflow
MSD leads, cap, and coil
CAI
Gents
I need some advise / help to diagnose my intermittent overheating issues.
Ever so often my heat gauge would start creeping up to about the 3/4 mark, and as soon as I start driving the gauge would drop.
It was initially diagnosed as a blocked radiator (aluminium), but after a 2nd...
As I have a EK4, I have AC and PS.
How do you guys rates this:
99-00 HONDA CIVIC Si B16 UNDERDRIVE CRANK PULLEY P03: eBay Motors (item 290412235562 end time Jul-08-10 19:31:48 PDT)