Will itr intake manifold fit b16 engine?

[darcygr]

I'm looking at modding my ek4 saloon engine a bit, just saw an ad someone selling a b18 intake manifold and throttle body for 120€!

Just wondering will it actually fit my car and would it make any difference to the power or am I better off getting something like a skunk 2 or spoon intake manifold for 4/500€

Here's the link to the ad for the picture of the manifold

Photo for Ad - DoneDeal

Thanks

 

[Wiskimike]

Should fit. Know 2 people who run b16 intake on b18c6 (no idea why)

 

[shuthanbala1]

I read somewhere that the B16 IM's are good from factory, so I wouldn't bother changing it unless you tuned the engine or running turbo.

 

[pateras_vtec]

I'm looking at modding my ek4 saloon engine a bit, just saw an ad someone selling a b18 intake manifold and throttle body for 120€!

Just wondering will it actually fit my car and would it make any difference to the power or am I better off getting something like a skunk 2 or spoon intake manifold for 4/500€

Here's the link to the ad for the picture of the manifold

Photo for Ad - DoneDeal

Thanks

for the money i`d get a tegiwa toda V2 replica

 

[stevenEK9]

he said INTAKE manifold, not exhaust

on a standard engine you will notice no difference, spend your money elsewhere

and yes it would fit, B18C / B18C6 use the same head as a B16, albeit the type R head has a bit of hand finishing inside the ports

 

[Vtec6000]

You will actually loose some low down torque fitting the type r intake manifold to stock b16a

 

[irf]

You will actually loose some low down torque fitting the type r intake manifold to stock b16a

Correct, as said above spend your money on something else.

 

[darcygr]

Great answers there people, thanks very much!

 

[darcygr]

Correct, as said above spend your money on something else.

Anything in particular worth spending money on to give the car a bit more power???

Wouldnt be into anything like a turbo or supercharger!

 

[vti2010]

I've noticed a huge amount of difference when I fitted ny skunk2 inlet and tb.

 

[darcygr]

You will actually loose some low down torque fitting the type r intake manifold to stock b16a

if i did get the type r IM and TB could it be mapped so that the power low down wouldnt be lost??

 

[e5k1m0 Sam]

See this thread as the same will apply to you, you will basically lose power all the way through the rev range so would be a waste of money

http://www.ek9.org/forum/engine/447...-good-upgrade-b18c-r-engine-3.html#post525309