robthedoc
civic disobedience
- Joined
- Feb 14, 2013
- Messages
- 1,533
ok guys I've been doing a build. Full engine rebuild b18c and full respray. Car is a 2000 ej9. Was well put together but was showing its age.
Long story short since rebuilding, the speedo on the s2k cluster stopped working. All other displays are fine but speedo reads zero.
It has a whiteford Davies Motorsport unit for the fuel and temp gauges and a speedohealer.
The healer has 12 volt in and Earth. Speedo input and out put. Basically I get the signal from the vss in so no worries there. However I seem to be getting a 4.6volt output from the vss input on the cluster. As in if I disconnect the in and outputs for speedo from healer I have 4.6v from vss and 4.8 from cluster.
Surely this is an internal cluster problem?
Long story short since rebuilding, the speedo on the s2k cluster stopped working. All other displays are fine but speedo reads zero.
It has a whiteford Davies Motorsport unit for the fuel and temp gauges and a speedohealer.
The healer has 12 volt in and Earth. Speedo input and out put. Basically I get the signal from the vss in so no worries there. However I seem to be getting a 4.6volt output from the vss input on the cluster. As in if I disconnect the in and outputs for speedo from healer I have 4.6v from vss and 4.8 from cluster.
Surely this is an internal cluster problem?