s300 mapping


kev_ek9

kev_ek9

Active Member
Joined
Jan 27, 2009
Messages
1,297
iv got hondata s300 finally ") I need a base map or the correct figures to put input. anyone got a basemap? or similar map to this setup. or know if the itr map would work ok?

b18c4 bottom end
ek9 head
skunk2 inlet
aem fuel rail
mugen 4-1 mani
pw jdm whales cock induction

cheers for any help
 
Use a tuner man.
Or load the base map from the software for the ITR, at your own risk.
 
I want to but need to run it in an dont know where there a good tuner near me that not scandalous haha so need to have a basemap to run an check before tunning
 
Will @ RDT will sort it....

Just trailer the car to him, or he may be able to send you a map to get it to him.
 
tow the car in to a tuner...you risk damaging the engine if you use an unknown map, base or not.
 
Ernie said:
Will @ RDT will sort it....

Just trailer the car to him, or he may be able to send you a map to get it to him.
Click to expand...

where he based? how much does he charge? how can I get in contact with him?
 
speak to Graham at Group B he mapped mine when it had a b18 in it, was a good map!!
 
kev_ek9 said:
iv got hondata s300 finally ") I need a base map or the correct figures to put input. anyone got a basemap? or similar map to this setup. or know if the itr map would work ok?

b18c4 bottom end
ek9 head
skunk2 inlet
aem fuel rail
mugen 4-1 mani
pw jdm whales cock induction

cheers for any help
Click to expand...

Just run the stock ECU and drive it carefully. Your setup is very basic so I wouldn't be to concerned about it. I've drove a fresh high compression B18C with big cams on a stock ECU for at least 50 miles. It's all about how you drive and that you ensure you don't put the engine under load.
 
so running the itr standard map from hondata will work fine to turn it over an make sure it runs and to get to tuner?
 
any ideas guys as I need to know if the itr map from hondata will be fine to make sure it runs and drive to tuner, mot etc
 
The S300 basemaps aren't great. Drop me a pm with the full spec of your engine including bolt on's and ill see if I can put you together a run in map.
 
any ideas is can use itr basemap to check engine runs? need to know asap please :) thanks
 
You must log in or register to reply here.
Back
Top