WayneCivic
New Member
- Joined
- Jun 22, 2013
- Messages
- 16
Hey guys
This is my small build I have copied it from the ITR forum. Enjoy
Right guys decided to start on my Teg with a slight wire tuck and a MASSIVE clean up!
Here's a few pics from this morning
How she started
After an hour
Wires all up clipped
Wires all gone
Wires in the footwell
How she's left for the moment
How to stop of today but will be adding more pics as the work continues
A few bits I picked up yesterday : Buddy Club front camber arms and rear arms also some 98spec front callipers
Also did abit more wire tucking today will get that side finished tomorrow
Update
Been very busy today.... Got the drivers side all finished and tested, and it STARTS
Also took the bumper support off to give it a touch of paint and wiper arms
All done
So started putting the drivers side back together, headlights needed a good clean!
Fitted the HID kit as well
So started to look at the passenger side to see what's involved
Under the dash is a lot easier with heater/AC parts out the way...
Hopefully weather will be kind tomorrow and I will get cracking!!
Also got a few new bits
Magnecor HT leads to go with the new engine bay colour
Air scoop for the bumper, not sure to leave it black or getting it painted when I go for the respray?!? Comments?
Thanks for looking guys will keep you all updated
That's it wire tuck all done!
Everything works and runs as it should, just need to start cleaning and putting everything back together.
Few pics from today
Need to start saving up for new bits now
This is my small build I have copied it from the ITR forum. Enjoy
Right guys decided to start on my Teg with a slight wire tuck and a MASSIVE clean up!
Here's a few pics from this morning
How she started
After an hour
Wires all up clipped
Wires all gone
Wires in the footwell
How she's left for the moment
How to stop of today but will be adding more pics as the work continues
A few bits I picked up yesterday : Buddy Club front camber arms and rear arms also some 98spec front callipers
Also did abit more wire tucking today will get that side finished tomorrow
Update
Been very busy today.... Got the drivers side all finished and tested, and it STARTS
Also took the bumper support off to give it a touch of paint and wiper arms
All done
So started putting the drivers side back together, headlights needed a good clean!
Fitted the HID kit as well
So started to look at the passenger side to see what's involved
Under the dash is a lot easier with heater/AC parts out the way...
Hopefully weather will be kind tomorrow and I will get cracking!!
Also got a few new bits
Magnecor HT leads to go with the new engine bay colour
Air scoop for the bumper, not sure to leave it black or getting it painted when I go for the respray?!? Comments?
Thanks for looking guys will keep you all updated
That's it wire tuck all done!
Everything works and runs as it should, just need to start cleaning and putting everything back together.
Few pics from today
Need to start saving up for new bits now