Hepl lock nut !!!!


OoXpGoO

OoXpGoO

New Member
Joined
May 28, 2009
Messages
73
Hi all !!!!

I have a big problem ...

I have a lock nut which has blocked and it is in a bad state :(( ....

I wanted to remove it but it was too tight and break ...

Look that pick !!!!



know if we can drill on this photo ....



if so, know where I can find the pin that corresponds ... ???

Or have you another solution ....

Thanks All !!!!!! :(
 
ok if you can get your hands on an air operated hacksaw "panel beaters use these" and if u cut threw whats left of the nut up to the actual stud which u can see in the pic u have up then it should seperate and if u can get a grip on it with a small longnose visegrips u should be able to get it off.
 
You should of just drilled down the side of the locking wheel nut untill it releases tension, if your carefull you can do it without wrecking your thread then just wobble the wheel about.

worked a treat when that happend to mine. :nice:
 
Drill it in the center of the bolt. Start from a small diameter drill bit and go up until you will hit the thread of the lugnuts.
 
Some people must think ''Hey i know what il do, Instead of the cheap easy option. Il take the long winded expensive option''

Thanks for that Lee, its people like that who keep my smiling no matter how **** work is.
 
Thank you for answer !!!

I'll try but for now it is not beautiful ...
 
You must log in or register to reply here.
Back
Top