I've recently aqcuired a Buddyclub Pro Spec cat-back exhaust, originally off and EG hatch, but going on my EK..
It fits, but the rear section of pipe (the "U" shaped part joined to the backbox that goes over the LCA) is fouling on the ARB.. From what I've read EG exhausts are a tad shorter than EK exhausts and looking at my car I can see that the backbox section needs spacing back about an inch and it'll no longer foul on the ARB.
My plan was to use an extra flange, between the joint (between the backbox section and the mid pipe) with a couple of longer bolts to space it all back abit, but I can't find any flanges in the right size/dimensions.. Does anyone know of anything suitable?
I ask because I do not want to cut it apart and weld it.
The bore of the pipework is 60mm, and it's a 2 bolt flange
Any help appreciated!
It fits, but the rear section of pipe (the "U" shaped part joined to the backbox that goes over the LCA) is fouling on the ARB.. From what I've read EG exhausts are a tad shorter than EK exhausts and looking at my car I can see that the backbox section needs spacing back about an inch and it'll no longer foul on the ARB.
My plan was to use an extra flange, between the joint (between the backbox section and the mid pipe) with a couple of longer bolts to space it all back abit, but I can't find any flanges in the right size/dimensions.. Does anyone know of anything suitable?
I ask because I do not want to cut it apart and weld it.
The bore of the pipework is 60mm, and it's a 2 bolt flange
Any help appreciated!