EK9 -> K20 swap


Wow this build is amazing and so inspirational
I wish you the best of luck getting it finished and hope to see some pics of you enjoying it as you deserve
Think I'm going to have to get a build thread up now
 
EK4 Luke said:
Wow this build is amazing and so inspirational
I wish you the best of luck getting it finished and hope to see some pics of you enjoying it as you deserve
Think I'm going to have to get a build thread up now
Click to expand...

Thanks so much for the kind words! :nice:
 
Kurtknight said:
yea thats what i always thought, the a/c guy just ran it too short but i'll just work with it still until i finish tune the car a/c works so it can wait.
Click to expand...

sounds great take a look at what i did may help

IMG-20131213-WA0092.jpg


IMG-20131213-WA0093.jpg
 
ChaddyP said:
sounds great take a look at what i did may help

IMG-20131213-WA0092.jpg


IMG-20131213-WA0093.jpg
Click to expand...

i was looking at your p/s setup the hood clearance, that 1 10mm bolt on the low pressure side i've been trying to figure out. any hints i would greatly appreciate because when that motor moves it'll touch mine already did whilst they were testing the hand control set up in Tampa

your a/c setup is what i've always had in mind but the a/c guy just did his own thing i'll have to get him to lengthen that line.

Thanks for the pics Brotha!
 
Last edited:
I just sat and read this thread from start to finish, needless to say I'm speechless... This build is on a level of its own, there's no other words for it! :shocked:

Your enthusiasm and drive as a person is an inspiration on its own!! DAT 9 THO :shocked: Unreal :nice: All the best mate!
 
thanks for the kind words! never let anything stop you, never let anyone tell you -you can't do something, with mental strength and drive anything is possible i think ;)
 
Last edited:
You must log in or register to reply here.
Back
Top