ek9 arch mouldings


siR david

siR david

Member
Joined
May 23, 2011
Messages
105
as above looking for arch mouldings as im running 30mil spacers..
anyone fabricate these for track/rally cars etc
looking for two sets for ek civics
doesnt have to be perfect alignment as its not a show car:nice:
 
Wazer said:
30mm is quite alot.. Thought of going custom? :p



Click to expand...

Right this is your last warning, stop posting sexy arch pictures where I can see them! Your car is too bad arse and it isn't good for my wallet!
 
^ hes right That does look pure sexual lol they over fenders smoothed onto the oem wing or???
 
Custom wing extensions. They are metal and have been welded and blended into the wing.
 
Ellis said:
^ hes right That does look pure sexual lol they over fenders smoothed onto the oem wing or???
Click to expand...

jesse888 said:
Custom wing extensions. They are metal and have been welded and blended into the wing.
Click to expand...


Jesse is right there, couldn't of said it any better :bow:

I'm sorry for the pictures pal, didn't mean to potentially harm your bank balance. :lol:

Few more for those interested though, the usual way of rolling arches didnt work out seen in first picture.. No looking Jesse! :nerv:






 
would love to have wings like them.
Do you know how they did it wazer? Looks like strips of sheet metal then welded together? How is it attached to the wing do you know? Could be a new DIY project for me lol
 
jesse888 said:
would love to have wings like them.
Do you know how they did it wazer? Looks like strips of sheet metal then welded together? How is it attached to the wing do you know? Could be a new DIY project for me lol
Click to expand...

As it was flared more and more, the metal started to thin out and crack - the cracks/gaps were then welded/patched up with the wee sheets of metal, then flared some more etc. Kinda in a circle from there mate.
 
Wazer said:
As it was flared more and more, the metal started to thin out and crack - the cracks/gaps were then welded/patched up with the wee sheets of metal, then flared some more etc. Kinda in a circle from there mate.
Click to expand...

Oh so the majority of that is still the stock wing just flared out? I won't have the tools to do it that way.

Thinking cap on!
Arch roller to push the metal out until it cracks, weld up and go again as you said. See if I can find a cheap ek wing and have a practice.
 
Last edited:
You what that would be easier like that, also make it easier to smooth out for paint seen as it's all the same panel.
Hmm.
 
You must log in or register to reply here.
Back
Top