UPDATE!!
I finally fixed it. Heres how you do it:
Order some rivnuts either m10x1.25 (asian) or m10x1.50 (European)
I got these from a seller on ebay all the way from Europe and it cost me $16 US with shipping. Comes in a 25 pack but all you need is 2 rivnuts. Thanks alot and would recommend ordering from them!
Next, get some bolts to match the rivnuts. Again if you got m10x1.25 then get m10x1.25 bolts. Make sure they are high graded. These are grade/class 10.9 bolts so they're very strong. Got them Autozone for about $2.
After that your going to need to drill out the holes a bit more from your civic walls so that the rivnuts could easily go into but fit snuggly.
(I just used a regular drill bit and went around the hole until the rivnuts were able to fit inside)
After the holes are big enough, test fit it with the rivnuts just to make sure they go in.
(don't hammer them in, you dont want bent rivnuts otherwise your bolts won't go in properly)
Next, get a ratchet or breaker bar with a size 15 socket metric or size 14 depending on your bolt. Also get a long extension so that you are able to torque the bolts easily.
Also a bar to hold the handle for more leverage if you don't have a breaker bar
Now what you do is you seat the rivnut onto the camber arm and the bolts to get it ready.
Put them into the holes and make sure they fit flush before you go and tighten them down.
Now you can tighten them down. Torque it down just enough so that the rivnuts stop spinning. Don't over tighten.
After loosen up the bolts and check your work.
Heres what happens to the rivnuts as you tighten them down onto the wall.
VIOLA! Put everything back together as usual. Remember to always put the 2 bolts on the wall first and tighten those down before you put the long 14mm bolt on from the bottom.
Problem fixed.