bigger brakes

[blissy]

can any1 help i need some bigger brakes 2nd hand or new for my ek9 rally car to fit in 15 inch rims thanks

 

[alan168]

what kind of size you lookin for?

 

[blissy]

4pots not sure what size just sumthing to fit in the standerd wheels

 

[blinx9900]

http://www.ek9.org/forum/photos-videos/9448-brembos.html

 

[Edu.T]

You can try the Honda Legend 2 pots from Fastbrakes.

 

[JIMBOB-EK9]

http://www.ek9.org/forum/photos-videos/9448-brembos.html

They wont fit behind the stock wheel BLINX.
I was looking into this a few month's back and to be honest i could only find the SPOON ones to fit really!

 

[iceman]

contact ap racing, can make just about anything you request

 

[dave benson]

do legend 2 pots fit behind standard 15" wheels, cheers

 

[JIMBOB-EK9]

contact ap racing, can make just about anything you request

I went to compbrakes Based in preston for the same thing, they had my hub & stock wheel there for about a week! they then came back to me & said they could not fit a decent 4pot behind the stock wheel, well there was one but they said it was for stopping cars less than 750kg so was not worth going for!
But said they could do a nice setup to fit behind 16" wheel for around £900 all in!

 

[dave benson]

ah remember that thread but couldnt find it again, i'll see how i go with 282 preludes and ds3000s as i dont want to compromise the gearing, cheers

 

[kaks_EK9Rx]

Spoon Twinblock? STEVEN EK9 on here is running them, maybe PM him for details on how they run and perform etc,

 

[JIMBOB-EK9]

do legend 2 pots fit behind standard 15" wheels, cheers

Yes they will!

 

[JIMBOB-EK9]

ah remember that thread but couldnt find it again, i'll see how i go with 282 preludes and ds3000s as i dont want to compromise the gearing, cheers

I think you will be fine with that setup mate!

 

[dave benson]

cheers

 

[PerformanceTek]

EP3 calipers and 300mm discs can be made to fit behind the OEM wheel

 

[60coaly60]

EP3 calipers and 300mm discs can be made to fit behind the OEM wheel

how ? have you done it before ?

 

[NelsonMoura]

how ? have you done it before ?

Hello

It´s possible but you need to drill the calipers in the corners

 

[60coaly60]

Hello

It´s possible but you need to drill the calipers in the corners

can you putup how to please

plan doing this myself now in the middle of trying to sort out ways i can get acess to a CNC mech no prob !

 

[PerformanceTek]

Hello

It´s possible but you need to drill the calipers in the corners

No you dont.