hey guys my engine is done stock and i placed a td04 turbo without a boost controler so it'l only be stock boost and i changed the fuel pump and i placed an fmu what do you guys think?
An FMU is pointless if you have Hondata. Honestly if I was the tuner I would have told you to get a proper set-up before you put those wheels on the rollers.
an FMU and upgraded fuel pump are okay to use temporarily, or only for people looking to gain very little power and run only 6psi. They work and are plenty safe when setup properly, there just not that fast.
an FMU and upgraded fuel pump are okay to use temporarily, or only for people looking to gain very little power and run only 6psi. They work and are plenty safe when setup properly, there just not that fast.
6 PSI isn't going to make a world of difference, but still will be enough to cause problems (head gaskets, pre ignition). Went down that road before. My advice is save your money until you can do a little internal work. Even if it's just going to be pistons and a gasket set up for boost, before you jump into any forced induction.
It's not Plenty safe when you get ping because your timing is too advanced...
your ECU was set-up for N/A. not 6psi of boost. You may have the correct amount of fuel. But that's only half the battle...
I think 6 psi on a td04 would be a problem on FMU + fuel pump only.
No boost controller = better for his setup as he would be running base wastegate pressure only. No boost controller is not such a bad thing, safety-wise.