Recent content by pumpingiron

Silicone grease is good for rubber and poly buches, antisize is....well you know when you change brakes in your car you put some kind of cooper grease so the treads don't jame next time you have to do the job right? Same stuff there put that kind of grease on the treads of LCA/endlinks bolts!

Well antisize on endlinks and bolts never hurts, as for sway bar buches is always good to put some water base grease!

Exacly, the tiny screws hows thightned to L brace is just to hold the "spacer" L bracket, so no need to torque it to much! As for the the attachement you got it right, longer bolt replace the OEM LCA to Subframe bolt and as for the "C" bracket is right there how that goes and facing like on...

X2 if you don't play with the compensator arm no trouble

Hey So this weekend i was able to take some pics of wath you requested, since i was putting some new lca! here it goes, 2 srews old the L piece: Then you put the brace in place with the new LCA bolts and when you put the bolt who goes inside the bar, inside the lca compartimente...

the biger L shape bracket going to atatch to de rear of the brace with 2 srews, the little 2 thiny brakets goes the other side of subrame when you thight the brace to the subrame, were the LCA is! I'm going to try to take some pics for you!

Well depends on alot of things, I tried KYB Gr2+ with Eibaich Sportline on my eg4/sir2 civic...was fun better than any oem combo, still was missing something, my mate use to trie alot of combos and he told me for the price he was not so much imprest of Tein! Good quality and better stifness...

I tried to talk to you guy´s troughout a portuguese site but without success! I´m going to e-mail you straight to your website e-mail adress to see!

You can buy conectors convertion on the side!

Innovative have good ones, for the 2 on the bottom just pus new OEM with ES insertes, as for the back also! Motor Mounts

Ya i trade my 96-99 itr cams to spoon one for 50 euros(65$us)...I get lucky I supose LOL ITR cams was in mint condition, spoon ones a little less...i supose the owner before use it with High rate springs, and since spoon cams are recast oem the material are less rigid than some aftermarket...

Over stock b16a....them yeahhhh, but only rising fuel pressure is not enought i went for LC1 and Hondata tuning to make it reliabel and good for smog test! I get it cheap, but if you want to buy new i think is a mistake, to expensive!

Very good work guys, now you must enjoy your work, I hope you let Accessory Zone take a ride.... Always so much fun when the car is running!!!! I started mine today also, always listen and see the fruit of your work!

So was the Module/Coil how was defect???

Humm that's explains a little.... So did you check your stuff to start the car???