Recent content by ÃrniVTI

for the moment just getting the car driving :P but i want to try 2.5bar/36psi or close to that and i'm not sure what HP number that is with the HX40 but just running the car over 22psi i'm happy this will be a street car, i just want to go low 10's :D

They are never a waste of money, they do an okay job of keeping the cylenders round, like i said they are wortless compered to sleeves or css but there are known cases of cars running hot but in my case there isn't a problem with it also on my friends mx125cc here on the forum zero issues and he...

That's not true, not a single overheating issue :D this is not close as good as sleeves or css but this doeas it's job when you are on a budget :D next thing i will do is order a block from CNC Werx just a supertech blockguard and it's not that expensive it's under a 100$ yeah i love...

Hi some of you seen this thread that my friend did http://www.ek9.org/forum/members-rides/17721-my-ek4-turbo.html but i bought the car in 2012 with a wrecked engine i changed out the crankshaft, bearings and got the car tuned again, drove it 20.000km or so and whent best 13.4 on that setup...

have you tuned on crome? because your philosophy doesn't work here. crome pro isn't free but it's cheap and it does all the same things that s300 does:D i'm running a p28 ecu tuned with crome pro with mac boost solenoid, i'm running boost by gear, hi/lo boost switch, antilag launch control...

awesome to see some of you just say plainly NO! but it's so wrong this summer i went with a bone stock b16a2 and we stopped at 1.3bars or 18.8 psi street tuned on 98oct fuel running Crome Pro/Gold and this was not with a small turbo i'm running Holset HX40(super 40) 60mm compressor wheel and...

Best run this summer on completly bone stock B16A2 @ 19psi with holset hx40

Best run this summer on completly bone stock B16A2

i wouldn't trust these. go with cp

do you have a photo with the gauges installed?

i haven't gone on the dyno yet. the lag is not horrible This is a 3rd gear pull 5psi @ 4600 7psi @ 5000 10psi @ 5600 15psi @ 6700 17-18psi @ 7100-8800rpm it isn't so bad. it pulls really hard and the exedy stage 2 clutch exploded in the first 1/4 try and this was after he changed to 4th

7.8sec 1/8 mile run on a stock B16A2 Honda Civic B16 Turbo stock motor 1/8mile 7.8sec (Iceland) - YouTube

i little update. the XSPower was dying so i bought a Holset HX40 .83 a/r with a 60mm compressor wheel.

here is a video of it from saturday in 1/8 mile.

i got tired of the OEM seats so i went a head and put these in p.s don't mind the dirt inside it. it was taken five minutes after they where put in. i gave the inside a good clean