Wheel resistance- videos (2),is it normal guys


Nah , thats not normal , if i was you i would take the caliper apart and clean all the rust that might on the piston itself , maybe it's not retracting properly , that would be my guess but i could be wrong
 
looks like ur 2 calipers are sticking,you could try bolting off the callipers and then spining the wheel to see if thats your problem... or else it could be a problem with your diff or diff bearings,i doubt it is tho!
 
looks to me that the piston is not retracting all the way back.
have you had that problem before with that brake set up ?
 
If those calipers were spotless I'd check out your brackets. I've had the same thing on my DC2. Put new brake pads on but my pins on the carriers were 100% stuck. I could barely move the car with my engine on.

Wrong section btw :)
 
JT is right hear guys, I'm 99.9% sure this will be caused by the slider pin's being stuck solid.

Remove your wheel & brake calliper & see if these pin's are free or stuck solid.

Moved to correct section too!:D
 
Ideally you should be able to move the pin with just a slight bit of pushing. A young kid should be easily able to do it. Mine were so stuck that even a hammer couldn't get them to move.
 
You must log in or register to reply here.
Back
Top