Tadman
Member
- Joined
- Oct 31, 2012
- Messages
- 196
i had a look on the forum quite abit and cant seem to figure out what this is :S
I bought this not so long ago and not too sure what to do lol
I have a Ek4 VTI Uk spec with B16A2 engine and am looking to upgrade my exhaust header, atm i have a Japseed 4-1 header (badly dented!) , Skunk2 decat "test pipe", unsure of the B pipe and a Spoon N1 back box
Firstly is this a genuine spoon 4-1 header?
And secondly what is this off? and what am i supposed to do now?
it fits the 4-1 perfect but has a 2" collector outlet? Surly i dont want this as this would be worse than my current setup of 2.25"?
Whats the best route to go down now? is there a 2-1 section i can buy that has a 2.5" collector and then get a 2.5" decat? would this mean i would have to get a 2.5" B pipe? And what about the N1?
Thanks in advance guys i know im asking quite a few questions its all very confusing, i read on here Honda never made a 2.25"? so confused haha
I bought this not so long ago and not too sure what to do lol
I have a Ek4 VTI Uk spec with B16A2 engine and am looking to upgrade my exhaust header, atm i have a Japseed 4-1 header (badly dented!) , Skunk2 decat "test pipe", unsure of the B pipe and a Spoon N1 back box
Firstly is this a genuine spoon 4-1 header?
And secondly what is this off? and what am i supposed to do now?
it fits the 4-1 perfect but has a 2" collector outlet? Surly i dont want this as this would be worse than my current setup of 2.25"?
Whats the best route to go down now? is there a 2-1 section i can buy that has a 2.5" collector and then get a 2.5" decat? would this mean i would have to get a 2.5" B pipe? And what about the N1?
Thanks in advance guys i know im asking quite a few questions its all very confusing, i read on here Honda never made a 2.25"? so confused haha