Stock EK9 headers bolt it to B16a engine

[JDM_EK4_HB]

Stock EK9 headers bolt it to B16a engine

Would it work well? improvements? added hp?

Any modification needed?

 

[joe]

A stock EK9 header should fit b16a, although you wont see any performance gains (correct me if im wrong) another thing to note is that it will have a JDM cat which is different fitment, opposed to a ukdm b16a2 cat, thing the JDM cat is slightly longer.

98 spec integra manifold is the far better choice!

 

[elchunk]

A stock EK9 header should fit b16a, although you wont see any performance gains (correct me if im wrong) another thing to note is that it will have a JDM cat which is different fitment, opposed to a ukdm b16a2 cat, thing the JDM cat is slightly longer.

98 spec integra manifold is the far better choice!

jdm cat is alot shorter than a ukdm cat! it is also a different dia at both ends. It will also hang a bit lower than a b16a manifold.

 

[Kozy]

You'll need a full EK9 exhaust system.

Dunno about gains as I went from a Tanabe SMR fart cannon to a stock EK9 system.

 

[joe]

thank you chunk

ps; fancy some portal co-op?