You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
stock ek9 air hose
- Thread starter cingli
- Start date
hey there - i need a stock rubber air hose from an ek9 that joins the stock airbox to the inlet manifold - my one is from a vti and therefore has two holes in it - an extra one for a sensor that the ek9 doesnt use
cheers
Arite mate, i had the exact same problem when i went to put the standard airbox back on mines, i just got hold of some rubber coolant hose, 10mm i think and jubilee clipped either end, its just an oil breather so isnt under any big pressure
yea - at the moment i have a cap over the end of it and then duct taped it off - but im lookin for a more permanent solution - being a perfectionist this method annoys me a lil
ideally would want a silicone pipe instead but cant find anyone who does something for the ek
ideally would want a silicone pipe instead but cant find anyone who does something for the ek
yea - at the moment i have a cap over the end of it and then duct taped it off - but im lookin for a more permanent solution - being a perfectionist this method annoys me a lil
ideally would want a silicone pipe instead but cant find anyone who does something for the ek
its 10mm inner diameter pipe you need, doesent need to be for the ek. check ebay and you will get some silicone pipe easy enough