Spoon ECU plug and play or no way ??


E

EK9-MATT

New Member
Joined
Apr 1, 2011
Messages
212
Wondering (proberly sounds daft question to most) could I buy a spoon Ecu and just plug it in? Or will it need mapping into my car? (from a set up car, 2nd hand )

Thanks
 
You need a knife and fork for it to work properly. j/k. Its just plug and play :nice:
 
I'm not 100% on the OBD difference between facelift and pre but you will have to make sure it's the right one for you car. Will be either OBD2 "a" or "b". If it's different it's not to much if s problem youngest need to get a conversion harness. There are plenty around to buy.

On a b16b the spoon ecu is not a massive gain. The b18cr responds quite well though. One of the best simple bolt ons you can do. : nice:

There is a comparison thread on here I'll try and find it for you.
 
Waste of money. get something that can be mapped properley.
 
Unless you don't have the money for mapping. Or if your in a remote area were there is nobody that does mapping.

I recon it's one of the best and easiest mods to do for the money. Those graphs are the proof.
I instantly noticed the gains when I fitted mine. Plus better mpg.
 
Last edited:
That is our problem in Gibraltar.. couple friends have tried mapping their Neptune ECU's and its not the same as getting it done by someone who is constantly fiddling with them using different mods etc..

i hve the Spoon ECU and it works well with my bolt on mods :))
 
KieranEG6 said:
Unless you don't have the money for mapping. Or if your in a remote area were there is nobody that does mapping.

I recon it's one of the best and easiest mods to do for the money. Those graphs are the proof.
I instantly noticed the gains when I fitted mine. Plus better mpg.
Click to expand...

This!
 
You must log in or register to reply here.
Back
Top