skunk2 cams stage2 pro,s no bottom end work


H

hooper

New Member
Joined
Nov 29, 2010
Messages
280
will i see much gains with these cams in type r teg ran of hondata s200 ecu with a good map...car has fourbranch good exust decat and good air intake
 
Have a chat with Will Ek9turbo on here. He's your man in the know :)
 
With stock b18c motor I got a 7 whp gain with skunk2 pro 1, I think you have to share with us the compression of your motor, but I t hink that you'll see a lot of gains with a good tune and with a 12.0+ compression.

Good luck.
 
not sure of conpression wouldnt be that high only a 96 motor with standered pistons
 
Go with stage 2 tuner series cams the pro2's are designed for a engine with internal work to raise engine compression. Should see about 10-20bhp increase with the tuner series stage 2 cams mapped and depending on condition of engine.
 
Pro Stage 2's on a standard bottom end will give you an increase in mid-range but not top-end, you need to raise compression to get the same rise at the top-end. This is what I found on a standard B16b bottom end, I'm unsure if there is much of CR difference between ITR & CTR bottom ends.
 
Vtec6000 said:
Go with stage 2 tuner series cams the pro2's are designed for a engine with internal work to raise engine compression. Should see about 10-20bhp increase with the tuner series stage 2 cams mapped and depending on condition of engine.
Click to expand...

What about the stage 2 tuner cams with stock internals? I mean stock pistons, stock cr. etc. (Of course the valve springs+retainers skunk2)
 
You must log in or register to reply here.
Back
Top