Item for sale: S80 LSD Gearbox, with 4.4 FD
Reputation: Need to start somewhere guys
Price: £450 ono
Paypal?: yes, if buyer covers fees.
Location: Tyrone, NI
Condition: 8/10
Description:
Gearbox is in very good condition, a bit dirty on the outside, but goes into and out of every gear fine. No whines or crunches at all. Will take every gear at 8400rpm and has no cause for concern. LSD grips well and is in great condition. 108k miles/kms done, mix. Good gearbox here, (better than the 4.7 imo)
Item for sale: DC5 Head (damaged)
Reputation: Need to start somewhere guys
Price: £100 ono
Paypal?: yes, if buyer covers fees.
Location: Tyrone, NI
Condition: 7/10
Description:
I have for sale a DC5 Head, WITHOUT CAMS. The engine bent a rod after sucking up water and 1 piston hit 4 valves and damaged them. I will be removing the cams and selling the head the way it is. the valve springs and other components and 12 valves are all 100% and in perfect working order. The cylinder that is damaged would need repaired and polished again to be right, but shouldn't be a difficult job for a machinist!
Reputation: Need to start somewhere guys
Price: £450 ono
Paypal?: yes, if buyer covers fees.
Location: Tyrone, NI
Condition: 8/10
Description:
Gearbox is in very good condition, a bit dirty on the outside, but goes into and out of every gear fine. No whines or crunches at all. Will take every gear at 8400rpm and has no cause for concern. LSD grips well and is in great condition. 108k miles/kms done, mix. Good gearbox here, (better than the 4.7 imo)
Item for sale: DC5 Head (damaged)
Reputation: Need to start somewhere guys
Price: £100 ono
Paypal?: yes, if buyer covers fees.
Location: Tyrone, NI
Condition: 7/10
Description:
I have for sale a DC5 Head, WITHOUT CAMS. The engine bent a rod after sucking up water and 1 piston hit 4 valves and damaged them. I will be removing the cams and selling the head the way it is. the valve springs and other components and 12 valves are all 100% and in perfect working order. The cylinder that is damaged would need repaired and polished again to be right, but shouldn't be a difficult job for a machinist!
Last edited:
