S2K cluster question


JDMDingo

JDMDingo

Spoon whore
Joined
Feb 26, 2011
Messages
310
Anyone who has done the s2k cluster install, can you please describe how you gained clearance with the plastic air pipe behind the cluster. Do you cut a section then patch over it some how so the air still flows? I got my AP1 cluster today, just waiting for my Wire-worx/ktuned harness to arrive. I test fitted it and seems like I need about an inch, which would be 1/2 of that pipe. I live in a place that gets really hot in the summer so simply taping over a cut out hole probably wouldn't last.

Any advice would be appreciated.
 
Last edited:
I've read that post.....he's the only person in any of the write up that mentions the pipe. His way looks very destructive, I didn't even think about using heat.
 
Some heat will be fine ,and if you have to cut ,you can always plastic weld a little piece over it ,
No big deal ;)
 
Cluster fits perfect, still waiting on the harness, signal convertor and bezel.

20160217_162227_zps9wjyubxb.jpg


Dash mod, air out put from the vent is the same.

20160217_170003_zpsrucf0sst.jpg
 
Last edited:
I was afraid to us a heat gun and the stray heat deform the dash above the tube.
 
Turned out good , what did you use to mend the hole ?
 
Layer after layer after layer of super ridiculous high tack electrical duct tape, since it is a duct an all. Changing direction each layer.
 
You must log in or register to reply here.
Back
Top