You measured with anything other than plasti-gauge? Personally I'm not too sure it can be trusted on its own.
See what the green gauge says, if it was N/A road car I'd run it boosted could be a risk though.
May well be fine I have no experience with this lol
Get some Clevite green plastigage, much better resolution than what your currently using.
Wish I knew what you lot are talking about lol
I'm clueless on engine building and internals.
Could use this thread to learn though as its very informative.
Got this on the way pal, should be good ?
Yes looks similar in resolution
One day il understand all this lolMeasured today with the different plastigauge. Definitely bang on 0.0015" clearance on the big end. What's my next best move ? If I'm bang on 0.0015" on reds, what can I expect from a set of HX Acl bearings, the information I find states they are the same size as the OEM Reds at 0.0587" although with an extra thou over std size OEM Green they should be 0.0581". Ideas?
One day il understand all this lol
Sweet ride. Keep up the good work