- Joined
- Jul 24, 2009
- Messages
- 6,294
I am getting a rumble feeling on hard right hand turns on full suspension compression. Like I am going over rumble strips. Previously thought it was the koni 3011's being worn out so swapped out to JRZ which I know were in proper working order...that too had the same rumble strip feeling. So I raised up the suspension and the issue has almost gone away but the ride height it too high up now [rumble is there too on full hard compression].
Has anyone experienced this?
Its not worn hubs/bearing as it only happens when under full load.
Ive asked around and many seem to think it may be worn axles. Im using RSX Type S axles 36mm hubs, its been suggested that I try out EP3 axles which are a tad shorter over the type s, but they would have smaller hubs as well which are also weaker than the 36mm hubs.
Anywho thought I would ask here to see if anyone has and insight on this issue.
thank you in advance.
Larry
Has anyone experienced this?
Its not worn hubs/bearing as it only happens when under full load.
Ive asked around and many seem to think it may be worn axles. Im using RSX Type S axles 36mm hubs, its been suggested that I try out EP3 axles which are a tad shorter over the type s, but they would have smaller hubs as well which are also weaker than the 36mm hubs.
Anywho thought I would ask here to see if anyone has and insight on this issue.
thank you in advance.
Larry