Got my shafts built up and fitted today so I could finally get all the front end bolted up and finished underneath.. just some clips for the new braided hoses left to fit.
I had bought a complete car HEL brake line kit last yr sometime.. finally got round to fitting it along with a bias valve, just need to change the rear hoses as I runs drums on the rear and the kit came with hoses for rear discs.
Nothing much to update.. just finished up my front brake hoses and got tyres onto the CPF's so fitted them and went back to the CPR's on the rear for some JDM stagger..
Been after a set of these wheels for ages.. would have preffered 15's but I'll manage.. 7x16 et35 Sprint Hart CP-035.. probly one of the lightest 16's you can get at 4.9kg per rim!
Cut splitter out and got some paint on it.. will need to sit it under traction bar so an airdam will need to be made to sit between lip and splitter.. some flexi plastic stuff should do it.. The mounts I will have to make and mount to outside of chassis legs.. as traction bar mounts on inside.
Started fitting my bonnet.. as its just a skin it needs 4 bonnet pins.. had to slide it forward slightly for clearence and some spacers will be fitted at edges to help it sit level.. I will be fitting a vent to it eventually.
Splitter and airdam mounted up today.. fabbed up some brackets from alloy and welded some mounts with captive nuts to the outside of the chassis legs as the inner side is used to mount the traction bar..