Question on exhaust fitament

[Cartney_265]

Going to be buying myself a 2.5" manifold in the next couple of weeks to replace my 2.25" one

Seen this one on nengun 5zigen - Header - Nengun Performance but it's listed as a dc2 manifold

Does this mean it will sit lower to the ground as it's made for the taller b18 block?

 

[eternal blue 2000]

correct!
your prob talking around 8mm lower approx

 

[Cartney_265]

Hmm 8mm shouldn't make it hang too low

Thanks for the reply

 

[kellsled]

itll be fine mate running a 5zigen 4-2-1 header on my jordan and it fits fine

 

[Cartney_265]

itll be fine mate running a 5zigen 4-2-1 header on my jordan and it fits fine

Is it a dc2 fitament one though? As eternal blue confirmed the dc2 fitament will hang lower fitted to a b16 block because it's designed for the taller b18 block

 

[Curtiz]

I thought that most 2.5 headers (for ek9/dc2) will hang slightly lower to, as you said, accomodate the lower block. Heard its about 10mm at most

Just got a 5Zigen header myself, fitting it tomorrow

 

[Cartney_265]

I thought that most 2.5 headers (for ek9/dc2) will hang slightly lower to, as you said, accomodate the lower block. Heard its about 10mm at most

Just got a 5Zigen header myself, fitting it tomorrow

oem 98 spec teg 4-1 hang very low and most other 4-1, but from the replies i've had should be fine with this 4-2-1

Where about you get it from if you dont mind?

 

[Curtiz]

Got it of a guy on Civiclife who was breaking his car. Yea 4-1 hang very low but 4-2-1 is pretty good