metal shavings in oil pan


PRESSURE CONVERSION CHART PSI-BAR

sorry im a psi person...this seems to be about a 10psi [1bar]drop.
37-66psi [2.5-4.5bar] seems low to me...WOT should be around 85psi [5.86bar]

Must be a older pump causing the lower pressure readings.

The round about you tested on is exactly what I was experiencing but mine was getting worse as time went on [lap by lap pressure was being lost]...which is why I have my current system like it is today. You will most likely not see that type of round about turn on track.

The moroso pan is a "B" pan.
 
Last edited:
I see well yeah i thaught it was a bit low too to be honest. not anyway i can get the pump to give more pressure ?

if not then well i mite flog the engine and get a b16b in there ... with lower miles mite be a better bet that worrying over this ....and no i wont see corners like that on the track i use.

and awsome i will look ino buying a moroso pan then
 
its just an old pump, lost a tad bit of pressure over time is all.

I replaced after I lost pressure on my new pump on a fresh build. this is not the case with yours. I would leave it as is and track it as you said.

knowing is half the battle tho, and you will not be surprised when it happens.
 
You must log in or register to reply here.
Back
Top