fitting OEM ek9 rear lip on ek/ej

[linh-ej9]

hey just bought a oem rear lip today and just wanted to know how you go about fitting it as it didnt come with parts to fit it, i know that there you are suppost to fit two screw on both side of the rear bumper but there are many more holes in side the lip which needs to be screw to the bumper i think, but my bumper aint got these holes to be screw in.

will 2 screw both side of the bumper be enough to hold it?

 

[linh-ej9]

bump

 

[jtjtjt]

i havent got a rear lip but hav got a frnt one , should be similar ,

im guessing screw 2 holes on each side, they dont come pre drilled so you have to drill a small pilot hole

 

[linh-ej9]

i know you can screw 2 screw each side but there are many tabs inside the lip, thats wat i want to know how you go about screwing them on to the bumper.

 

[Charlie_EG]

Just do the side ones it will be right

 

[linh-ej9]

Just do the side ones it will be right

but if you do just the side the middle will hang low and leave a gap

 

[Frodo]

Just put self tapping screws through the centre tabs, and it'll all hold fine

 

[ultra xb3c]

have you got it fitted yet m8?

 

[linh-ej9]

have you got it fitted yet m8?

nah its sat in my kitchen, too lazy sand it and paint.

 

[Curtiz]

How much are ek9 rear lips going for now roughly?

Just need to know before i mount my exhaust, thanks

 

[linh-ej9]

about £180 new i think.
2nd can be from 50 to anything

 

[Pedram]

I wouldnt just put the side screws in cuz 1. it hangs lower in the middle 2. it wont be safe as it might come off!
Just use self tappings screws and it should be fine.