Cylinder head b18c b16b


A

andyrob

New Member
Joined
Aug 24, 2011
Messages
264
I need a good used cylinder head for my ek9 im going to build a big spec engine and i need a head either Good condition standard or already worked anything considered from a little port and polish on a bare head to big valve wild cams full race spec. pm me details
 
I've got a B18c6 Head Complete apart from the cams for £230
 
Standard ITR head here. Complete minus cams, so has all cam caps, valves, valve springs and retainers all fitted. Good condition, in touched. £170 plus postage. I'm up in Falkirk/Edinburgh if you'd rather collect, couple hours drive each way.

PM if you're interested

Cheers

Steve
 
have very high spec head, oem internals (valves maybe aftermarket), fully re built/worked few years ago, not cheap but if interested can discuss further (made 202bhp 136/ft lb on oem stock internals on b16a2)
 
I have a B16a bare cylinder head which has recently been pressure tested and had a 0.010" skim. I intended on using it for my own build but have since change my plans. £70 colleted
 
I have a fully rebuilt b18c6 (with receipt to prove) head. Stripped down, cleaned, pressure tested, valves lapped in, 40 thou head skim, oem valve stem oil seals installed. Fully cleaned externally and comes with a fresh refurbed rocker cover. Total cost for me £725 inc head purchase

Just want shot now £450 delivered

Pm me as am open to offers at the end of the day
 
You must log in or register to reply here.
Back
Top