Carbing 3 point bar install advice?

[ek9can]

Having a little fitment issues I didn't realize that it would be a lot easier to install without some oem brackets that hold wiring on the drivers side shock tower and my a/c line on the passengers side is going to be quite snug as well.

And for those of you who did install I have a bracket where my fuel filter is that holds the throttle cable as
well i'll attach pictures. did you cut it off?

I had a closer look at it and I'm going to trim the top piece off the wire bracket and I think it will clear but as far as the other bracket Im guessing it has to be cut off?

 

[b16 mini]

Shouldn't need to cut anything off, just un bolt a bracket,
Post some pictures up to show the problem

 

[ek9can]

 

[b16 mini]

If I remember correctly you can just bend that bracket down a it by hand

 

[ek9can]

ya i guess i could won't look very good tho. but I definitely have to cut the bracket that holds the wires because the master cylinder brace goes right down in that spot.

 

[ek9can]

I got the bar installed but I had a few fitment issues but nothing serious. It pushed my a/c line over and I can't use the hold down bracket anymore. and the master cylinder brace pushed on my spoon intake and ended up pushing my air box up into my rad support