Ball Joints and Drive shafts

[Mallyauto86]

Ok couple of things the boots on my camber adjuster upper ball joint is gone can i replace the ball joint with a standard unit onto the plate or do i have to buy another camber kit ?

And can somone tell me how to remove the drive shaft's out of the Gear box i've removed them from both hubs but they dont seem to move out of the box no matter how much wobling or tugging i do.

Also are the Buddyclub roll centre adjusters really worth the money ? as i've knackerd both my ball joints on the lower end.

 

[Championship White]

Use a large screwdriver and lever it out. I just finished changing a CV boot on my EG, right pain in the arse!

 

[Mallyauto86]

i've tried that wont budge lmfao

 

[Kozy]

You've got the shafts out of the hubs? They just slide out of the diff casing...

 

[Mallyauto86]

slide ? hmm they wont for me i'l have another go tonite

 

[boro_andy]

They're held with a spring clip are they not? So shouldn't just slide out exactly! Or a circlip whatever you wanna call it!

 

[Uraco]

They're held with a spring clip are they not? So shouldn't just slide out exactly! Or a circlip whatever you wanna call it!

Something like a circle spring clip and yes they would not just slide out.

Try a pry bar and give it a few nudge and it should release. If not barging then turn the drive shaft a quarter turn and try again.