B16b into a eg esi auto


E

Ek410101

New Member
Joined
Sep 24, 2011
Messages
19
Hi there . . Probably been asked a million times before. So sorry in advance. But im a complete noob . .

Just want to know im planning on buying a esi auto. Will the ek9 b16b go into the eg quiete easily r will it be alot of headache . .????
And wot are the procedures. I.e wot iv got to change??

Cheers guys
 
I converted a auto eg6 to a manual and it was a real pain.
Apart from the gear box, clutch, flywheel, gear linkage, slave cylinder, pipe work, master cylinder, pedal assay, rear engine mount bracket, gear box mount, dash cluster.
You will have to cut off the gearbox mount off the chassis and re weld it. Also cut hole for gear stick.
Good luck, Dunx
 
you can buy a auto to manual mount off U.S ebay to save cutting the box mount
 
I have got the full front end of an ek9. . . All interior is stripped. Just got the shafts. . Gear box engine . Everyrhing under the bonnet . . . Would that be enough . ?? And wots the procedure ??
 
I'm costing up a similar project - did you do this in the end and what level of hell was it?
 
You must log in or register to reply here.
Back
Top