Ali_D
New Member
- Joined
- Feb 22, 2011
- Messages
- 19
Clifford don't like to publish this information, heres some info on adjusting your duel-zone proximity sensor on a Clifford G5 alarm. Enjoy, Ali
Programming Dual Zone Proximity Sensor.
NOTE: ALARM MUST BE UN-ARMED
1) Press Clifford button 3 times then * once. You will hear a chirp and the LED will stay on.
You are now in the inner zone. Wait 15 seconds
2) Press * button to decrease sensor, boot release button to increase.
Lean into the car through an open window to test, when the alarm senses you there will be a chirp. Again, from here you can increase or decrease it's sensitivity and re-check.
3) press ** to enter outer zone and again wait 15 seconds.
4) Repeat section 2, stand by the car window (closed) until a chirp warns that the sensor has been activated.
5) Press padlock once (2 chirps follow) to exit back to inner zone, press padlock again (3 chirps follow) to exit completely
Programming Dual Zone Proximity Sensor.
NOTE: ALARM MUST BE UN-ARMED
1) Press Clifford button 3 times then * once. You will hear a chirp and the LED will stay on.
You are now in the inner zone. Wait 15 seconds
2) Press * button to decrease sensor, boot release button to increase.
Lean into the car through an open window to test, when the alarm senses you there will be a chirp. Again, from here you can increase or decrease it's sensitivity and re-check.
3) press ** to enter outer zone and again wait 15 seconds.
4) Repeat section 2, stand by the car window (closed) until a chirp warns that the sensor has been activated.
5) Press padlock once (2 chirps follow) to exit back to inner zone, press padlock again (3 chirps follow) to exit completely