Search results

As above. i'm after a full set of Ek4 injectors as cheap as possible. PM will be the best way to contact me. thanks Ad

hi. i realise this might have been covered before (if so a link would be nice) but i'm struggling with putting my ek4 engine loom onto my b16a. i have most of the plugs on but there is a few that are catching me out. i was after a plug by plug how to if there is one? as stated there is only...

Im just after a definite answer as I think most of you will know. Which b series loom can I use to get my b16a running in my pre facelift ek. Can I use an mb loom and integra loom? Or does it need to be from an ek4/9. Thanks Ad

As above im after an uncut b series loom for pre facelift. Thanks

Hi. As above ive just got my new gearbox for my conversion. Got a low mileage s4c. Is it ideal to change the release bearing before I put the box on? Thanks. Ad

hi guys. just need to know if there is a different plug for the vtec solenoid depending on what year the car came from i.e. obd's thanks in advance. ad

hi. been lurking on this forum for a while now and its about time i started a build up. its taking me forever, due to recently having a baby and working daft hours. i barely get much chance to work on it. but here it is anyway this is how it sat for a while a couple of months after i first...

Hi as above need some help. I recently got an engine conversion that came with a cable box. Ive bought a s4c for it but Will the drive shafts still be okay to use? Or is there a difference between cable and hydro ones? Thanks

Ive always been led to believe when swapping from my d to a b I could keep my upper gearbox and cam side engine mounts. So ive bought all the other necessary mounts. But looking at the cam side mount from my d series today it has only two bolts holding it to the engine whilst the mount that is...

Hi im after a few bits. Thanks Obd2a distributor rocker box washers. I know tegiwa sell the washers but just after some oem (cheap) ones

hi i'm in the middle of doing a b16a swap into my ek. wanting to use a P30 ecu. will i have immobiliser issues when i come to start it? and if so how do i get around it? thanks ad

can someone please take a photo of their passenger side (engine side) torque bracket for me? struggling to find a picture. thanks

as above. Im after the rear l bracket and front lower engine bracket.

i'm in the middle of a very slow engine conversion. but i've bought a new clutch as i figured its a lot easier to replace whilst the engine is out. and just wondering whether it would be beneficial to go with a lightened flywheel?

Hi everyone. new to this site. Haven't got an ek9, which is why i haven't signed up earlier. but turns out a lot of people on here don't have them so... here's my civic anyway just in the middle of an B16a engine conversion. trying to source the last few parts for it.

as above i'm in need of 3 mounts (lower gearbox, lower engine and rear l bracket) cheap ek gearbox and ideally i need a un immobilised ecu.