Recent content by VinnyEK

thanks for the help lads il keep ye updated !

ran a test today and its 9 cylinder sensor and 41 primary oxygen sensor heater, any idea how to rectify this lads?

My ek4 b16b dosent feel like its running right , holding back alot not pulling as it should espically in 2nd . when i turn on the inginition theres no engine management light could this be the issue if so anyone ideas where to get a bulb?

any new codes lads ?

ya piston is free , just really want the rubber alone that seals from water and dirt into the slider . dont sell them anywhere so im going to try repair the rubber :)

they're ek9 calipers

got the slider out eventually with alot of force , got rid of the corrosion and cleaned inside and out . afterwards i noticed that there was a small hole in the rubber of the slider . (caused it to sieze in the first place by letting water in) any idea where to pick these up besides buying a...

thanks for the help !

so you reckon just to take apart the slider clean all the inside and use grease ? il give it a try anyway !

is that for one side or 2 ? thanks for quick reply

my drivers side front caliper the slider on the bottom is seized just wondering how i would go about repairing them ? or would it be easier to get a new caliper , any help appericated

hopefully ! can anyone describe what its meant to look like new ?

found out the hunting issue it was a loose vaccum line ! opened up the distributer today and there was debre inside it , i presume this is my misfire problem ? grtting a new one friday so hopefully it will sort it

annoying isnt it , have asked a few people but no one really knows

Idle in the car is very jumpy . when the car is started it idles grand but when reved starts hunting fairly bad (video attached) tryed cleaning the idle control vavle and it was filthy , this helped a small bit but still not great. the when you release the tension the lead going up to the icv...