X Brace


turbowizard

turbowizard

if in doubt,flat out
Joined
Feb 22, 2010
Messages
61
would some1 with an x brace mind posting or taking some pics of all the joints in the drsign. My bro is a fully coded welder and was thinking he could make 1.
 
wouldnt be that hard to make with out pictures.

if u get the correct measurements and knwo how to weld i dont c y u could make 1.
 
its just for the joints mainly, i have managed to sus out everything else but the joints on the pillars, kinda struggling to make a decent connection and just want to see how its done on others.

Iv searched for pics but cant find for the joints i need.
 
if you get a rear strut brace that has detachable mounts either side..

you can simply use these to mount the X brace on...thats basically what tegiwa did.

in fact i used my X brace with the X for a while and just used the lower strut bar...
 
i was told to make templates out of cardboard and my bro would gut them out but its the top joints i dont no where to attach them to the pillar.

this is more just for a test to see if he can make a good one then if any1 wanted 1 he could make more as my bro is a pretty s**t hot welder.

or do you (^^^) mean an rear upper strut brace?
 
well the upper strut connects where a C pillar brace would go.. search for C pillar braces and you will see what i mean... just mount the X to the seat belt shoulder mount bit and the bottom bit goes to the strut towers...

:) good luck dude and to your brother and be sure to show pics of what your brother can do with his skills.
 
You must log in or register to reply here.
Back
Top