were do i disconected the wire


C

CivicBoy P840

New Member
Joined
Dec 9, 2011
Messages
8
were do i disconected the wires from the passager side 2 to do a conversion from a mb6 1998 engine into a ej9 1995 ? all replies would be very thank full caz mb6 engine is striped away from the wires ang the ej9 shell is ready 2 go and conversion is ready 2 go and needs done 2 day
 
The engine wiring loom will run through a gromit and hole in the passenger side bulkhead through to the ECU. Disconnect it from inside the car and loosen the 10mm bolts that hold the gromit in place. You will be able to pull through the plug end of the loom. Providing you have removed the plugs at the drivers side (UK car) you shouldn't have to remove much more of the loom to get the engine out.
 
wat about the wires that run behind the dash board can i cut the wires and connect them 2 my loom that runs behind my dash board will this work ?
 
You must log in or register to reply here.
Back
Top