Take performance to a B16A2

[Lopallo]

Hi I would like to share views on how to take advantage of a B16A2.

Putting a line of full exhaust, intake manifold, stage 1 clutch, lightweight flywheel and air filter high flow.
By putting this would have to reprogram the ECU?

What I'm looking for a very aesthetic JDM with a better engine performance, but if you touch anything inside the engine to have long life.

It occurred to me to open this post to share views on the preparation of this engine.

Thank you very much and begin the debate

 

[kevtegra]

Power Chamber induction kit (J's Replica), ITR throttle body, ITR cams, Full 2.5" exhaust system. That would be the start of what you would see nice gains from. You COULD run without a map but you would be better off getting the likes of an APEXi Neo and getting it fine tuned. The clutch and flywheel would be a nice upgrade too but unless there is something wrong with your current clutch i would hold off and spend the money on the other items above first.
Ive seen the above done on an EK4 saloon and would highly recommend it!

 

[Lopallo]

Power Chamber induction kit (J's Replica), ITR throttle body, ITR cams, Full 2.5" exhaust system. That would be the start of what you would see nice gains from. You COULD run without a map but you would be better off getting the likes of an APEXi Neo and getting it fine tuned. The clutch and flywheel would be a nice upgrade too but unless there is something wrong with your current clutch i would hold off and spend the money on the other items above first.
Ive seen the above done on an EK4 saloon and would highly recommend it!

I had commented that had served him to pieces B16A2, you mean the DC2?

And the Apexi NEO is hard to use?

Thanks friend

 

[RagingAngel]

I had commented that had served him to pieces B16A2, you mean the DC2?

And the Apexi NEO is hard to use?

Thanks friend

Where are you located and what is your expected budget and power goals?

EK9.org JDM EK9 Honda Civic Type R Forum - Announcements in Forum : Engine

 

[kevtegra]

You could wire the neo in yourself if you can follow wiring diagrams, then you will need to bring it to a professional to map it unless you have experience doing this yourself with wideband sensor etc (which im assuming you do not)

The EK4 saloon has bet a lot of things, there is a vid on youtube of him beating a 3ltr (na but still ) supra. Search for EK4 vs supra