Spoon intake elbow install question

[ek9can]

Just picked up a spoon intake elbow for my ek9 and a factory intake box to replace the sri that's on it now. Was wondering where the elbow bolts to the car does there need to be a rubber mount or anything. It feel like if it flexes at all it will break. Or do I just bolt it to the bolt it directly no hardware came with the oem intake I bought.

 

[linh004]

The spoon intake elbow attach to the throttle body and is tightened down with a jubilee clip. You can reuse the old one on the car right now. The other end of the intake elbow goes into the air box and is fastened down by a spring that wraps around it, like a jubilee clip. The factory intake box will bolt down by 3 bolts. Again, just reuse the old hardware.

 

[ek9can]

I don't have the hardware for where it bolt up the strut tower I seen a few pics online and there is something like a rubber spacer is that oem or does it come with the elbow

 

[Biscuit]

Just use an m6 bolt and some generic rubber washers. Easy.

 

[SarahVTEC]

The rubber spacer/washer you're referring to is OEM hardware from the stock air box. Instructions say to place the elbow fin on top of this spacer and put the bolt through it. However, some users have broken the fin in this position and just use the bolt. It is up to you. The spacer keeps the elbow at a proper height; whereas, without it the elbow and air box will sag or droop a bit. You need 1 of each of the OEM parts below. Hope this helps!

Part Numbers:
90029-PHM-000 BOLT-WASHER, SPECIAL (6X35)
[URL='http://www.hondapartsunlimited.com/honda/civic-coupe/17212p2jj00/2000-year/si-trim/5-speed-manual-engine/electrical-exhaust-heater-fuel-cat/air-cleaner-vtec-scat/?part_name=rubber-air-cleaner-mounting']17212-P2J-J00 RUBBER, AIR CLEANER MOUNTING[/URL]
[URL='http://www.hondapartsunlimited.com/honda/civic-coupe/17212p2jj00/2000-year/si-trim/5-speed-manual-engine/electrical-exhaust-heater-fuel-cat/air-cleaner-vtec-scat/?part_name=rubber-air-cleaner-mounting'][URL='http://www.hondapartsunlimited.com/honda/civic-coupe/17216pn3000/2000-year/si-trim/5-speed-manual-engine/electrical-exhaust-heater-fuel-cat/air-cleaner-vtec-scat/?part_name=collar-air-cleaner-mounting']17216-PN3-000 COLLAR, AIR CLEANER MOUNTING[/URL][/URL]

 

[ek9can]

Perfect thank you I got them yesterday that's gonna work I will post pictures in my build thread I still need the hose from the valve cover to the intake first tho.