About time I update this! over the past 4-5 years I've added the following parts
Engine/transmission:
tegiwa dress up bolts
carbon bonnet dampers
b18 inlet manifold bored out
skunk throttle body
k20 fuel rail and injectors
type r head skimmed,ported,polished and valves reseated
new honda rings
skunk 2 manifold
full mugen twinloop system from mani back
new honda thermostat and coolant flushed
new honda engine gaskets and seals kit
s80 gearbox 4.9 final drive
exedy clutch kit and release bearing
fidanza flywheel
lightweight crank pulley
carbon slug intake
gear linkage rebushed
new honda seat change lever ball
new throttle cable and bracket
Suspension:
new yellowspeed coilovers
hardrace adjustable rear toe arms
hardrace adjustable rear camber arms
new honda dc2 lower control arms
new honda rear trailing arm bushes
18mm ultra racing rear anti roll bar
hardrace arb droplinks
ultra racing rear lower tie bar
new inner and outer tie rods
new front upper control arm bushings
new front upper control arm balljoints
new hardrace lca bushings
new honda suspension bolts
15mm front and back wheel spacers
Brakes:
ek9 front callipers and carriers
fully refurbished(pins/piston/seals etc sprayed factory gold
mg 282 and 262 drilled and grooved discs
new gen honda master cylinder
new gen honda slave cylinder
ferodo DS2500 F&R pads
HEL braided brake lines
Exterior:
gen honda mudguards
spoon replica mirrors
s2000 wheel nuts
front wipers repainted
carbon replica spoon spoiler
Interior:
red recaros
personal red stitched leather steering wheel
new radio and speakers for door cards yet to be fitted
Integra type r mats
boot floor cleaned and resprayed
new honda fd2 gearnob
new honda alum pedals, yet to be fitted
Will get photos up of the progress in the next day or so.
Car is finally getting to where i want it. Next up is to get my suspension geometry set up and back on the road for the Summer.