Low ride + DriveShaft 2.9

[Shift]

Hey guys,

SO i busted up the inboard joints on my Level 2.9 DriveShaft Shop Axles... had them installed now for about 5 yrs. So its off to order a new set. I get them and the shaft is slightly thicker...the inboard joint housing (outside the gearbox) are bigger than the older ones.... now apparently i got to raise the car up from being so low cause im getting a knocking at slow speeds...anyone here has this problem as well? Im currently rolling on standard EK9 wheels and tire size (195/55/15). I like the low look the car handles well...is there anyway that u guys know of that i can get away without raising back up the car totally?

 

[Lynch]

How low is your ride height? You can certianly run the car lowered with very little extra stress on the driveshafts as they have a large range of motion, but I am uessing your car is really low.

 

[Shift]

nope...i actually brought it back up to standard height now n its still knocking so i gotta send them back. my height was just at the top of the tire front and rear.