k24 turbo

[ross_ek3]

looking at putting a k24 frank into my ek4 , i have the engine etc but now thinking about a fully built turbo setup

could i run on standard internals ?

what sort of pistons\rods would i need if i was to build engine ?

 

[ALEX-CY]

 

[Murray]

Cant see why not. Go for it.
just make sure the tuning is good and you don't cut corners.

 

[oscarsayco]

We ran stock internals on a k20a2 motor.. before building the engine..
And we put down 530whp on q16.. in tank 255 pump, 1000cc injectors, presicion b.b 67/68...

On a built motor we squeeze almost 800whp
Sleeved block
Manley turbo rods
Wiseco 9.1 cr
Weldon 44 pump
2000 cc injectors
Afi center feed intake manifold
Accufab throttle body 90mm

 

[ALEX-CY]

New
We ran stock internals on a k20a2 motor.. before building the engine..
And we put down 530whp on q16.. in tank 255 pump, 1000cc injectors, presicion b.b 67/68...

 

[msc52]

This is what I am doing into a dc2, just going to use the stock engine but with ARP head studs but only boosting to 8 - 10 psi not looking for massive horsepower!!!